10.8V Ø85MM CORDLESS CIRCULAR SAW -
BODY ONLY
MODEL NO:
CP108VCSBO
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
Always work with the saw safety guard in place.
9
Maintain the tool and battery in good condition. Check moving parts alignment on a regular basis.
9
Replace or repair damaged parts. Use an authorised service agent and recommended parts only. Unauthorised parts may be
dangerous and will invalidate the warranty.
9
Ensure the tool is switched off before installing the battery pack.
9
Keep the tool and charger clean for best and safest performance.
9
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and contain long hair.
9
Evaluate your working area before using the tool; e.g. ceilings, floors and enclosures may contain electrical items or water piping.
9
Ensure battery pack is correctly inserted into the handle and latched in place before attempting to switch on tool.
9
Check the blade to ensure that it is not split, cracked or damaged in any way. If in doubt
DO NOT
use the blade.
9
Secure loose work pieces with a clamp, vice or other adequate holding device.
9
Avoid unintentional starting.
9
Wear approved safety eye protection (standard spectacles are not adequate).
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-skid shoes.
9
Keep direction switch in the locked position until the tool
is required for use.
9
Keep children and unauthorised persons away from the working area.
8
DO NOT
use the tool where there are flammable liquids, solids or gases, such as paint solvents, etc.
8
DO NOT
allow children to operate the tool.
8
DO NOT
operate the tool
if any parts are missing as this may cause failure and/or personal injury.
8
DO NOT
switch the saw on whilst the blade is in contact with the workpiece.
8
DO NOT
leave the tool operating unattended.
8
DO NOT
carry the tool with your finger on the power switch.
8
DO NOT
use the tool for a task it is not designed to perform.
8
DO NOT
operate the tool
when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT
get the tool or battery charger wet or use in damp or wet locations.
8
DO NOT
touch the workpiece immediately after cutting as it will be very hot.
8
DO NOT
hold unsecured work in your hand and
DO NOT
touch the saw blade whilst operating
8
DO NOT
leave the saw running unattended and
DO NOT
lay it down whilst it is running.
8
DO NOT
cover the saw air vents. To do so will overheat the machine.
WARNING!
DO NOT
use on materials containing asbestos.
2. INTRODUCTION
Compact, lightweight cordless circular saw - body only. Comfortable housing with soft grip to help reduce vibration. Supplied with
1 x wrench for removing and replacing blades. Requires compatible 10.8V 2Ah or 4Ah battery and mains charger, sold separately.
3. SPECIFICATION
Model No: .......................................................
CP108VCSBO
B
lade Diameter .........................................................
Ø85mm
Consumable Parts ........................................................ ........
C
P108VBP 2Ah Battery (not included)
C
P108VBP4 4Ah Battery (not included)
C
utting Depth at 90
o
.....................................................
26mm
C
utting Depth at 45
o
..................................................... 17mm
D
isk Bore Size
..........................................................
Ø15mm
Noise Power/Pressure .........................................
88/77dB(A)
No-load speed .......................................................
0-1450rpm
Replacement parts .....................
CP108VMC - mains charger
V
ibration/uncertainty ........................................
3.368/1.5m/s²
4. PREPARATION
C
P108VCSBO Issue 1 19/04/21
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection
Wear protective
gloves
Wear ear
protection
Wear safety
footwear
Wear protective
clothing
Wear a mask
