4.2.
Display general
By pressing the
< (forward) and > (backward)
buttons the display will cycle through the options.
Press
enter
button when the option you require
is displayed.
use the
<
(forward) and
>
(backward) buttons to select
language or press enter to
commence battery test
use the
<
(forward) and
>
(backward) buttons to return to
battery test or press enter to set
language.
use the
<
(forward) and
>
(backward) buttons to select
language.
english, french, German, spanish,
Italian, Portuguese or Japanese.
Press enter to confirm choice
and return to battery test.
warning!
ensure that you read, understand and apply the safety and operational instructions before connecting the tester clamps to
the battery. only when you are sure that you understand the procedures is it safe to proceed with the testing process.
4.1.
preparatiOn
warning!
Ensure that the vehicle, or battery, is in a well ventilated area before starting to test.
4.1.1. check battery casing for cracks or leakage. If damage is found
DO nOt
test, replace battery.
4.1.2. clean battery terminals.
4.1.3. If possible, check electrolyte levels and top-up with distilled water as necessary.
4.1.4. unless otherwise specified, tests are carried out with
all
electrical items switched off.
leaving any items on (boot light, interior
light, etc.) can result in misdiagnosis.
4.1.5. confirm that the 4 x AA Batteries (supplied) are correctly fitted (fig.2) in the compartment in the rear of the tester. Batteries are best
fitted with the rubber jacket removed (fig.3)
note that nothing will be seen on the display until the tester is connected to a vehicle battery.
4.1.6.
connect the red clamp to the positive (+) battery terminal and the black clamp to the negative (-) terminal. When the internal battery
becomes discharged the display will read
internal Battery lOw.
4.1.7. If there is a poor connection the display will read
CheCK ClaMps
, otherwise the display will read
Battery test.
4.1.8. Paper load: open the clear cover. Insert the paper in the feeder, it will auto feed in to the printer.
4. OperatiOn
Original Language Version
Bt2013.V5 Issue: 1 - 28/11/14
© Jack sealey limited
4. COntents
Item......... description.............................................. Qty
1.............. Analyser/lead/crocodile clips................ 1-set
2.............. rubber Jacket......................................... 1
3.............. Printer rolls............................................. 2
4.............. "AA" 1.5v Batteries.................................. 4
5.............. Blow mould carry case...........................1
2
4
3
5
1
BAcK
forWArd
enter
4.3.
Battery test
4.3.1. With battery test screen displayed press enter.
4.3.2. use the
<
(forward) and
>
(backward) buttons to select the battery type: regular liquid, AGm flat Plate,
AGm spiral or Gel. Press enter to confirm choice.
4.3.3. use the
<
(forward) and
>
(backward) buttons to select the battery rating: sAe, en, Iec, dIn or JIs.
Press enter to confirm.
4.3.4. use the
<
(forward) and
>
(backward) buttons to input the battery capacity.
ccA:
dIn: 25 - 1300
en:
40 - 2100
Iec: 30 - 1500
JIs: By battery type
sAe: 40 - 2000
fig.1