I N S T R U C T I O N S F O R :
CV JOINT BOOT CLAMP KIT
MODEL NO.
BSL102
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
BSL102 - 1 - 281004
1. SAFETY INSTRUCTIONS
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE OR
PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
2. SPECIFICATION & CONTENTS
SPECIFICATION.
Banding is 430BA Stainless Steel, 5.5mm wide and 0.4mm thick.
Tensile strength of banding: . . . . . . . . .480N/mm
2
Stainless Steel Band Cassette: . . . . . .183ft. (56 mtr)
Seals: . . . . . . . . . . . . . . . . . . . .x150
Pliers: . . . . . . . . . . . . . . . . . . . . . .x1
Dispenser: . . . . . . . . . . . . . . . . . . . .x1
1.1
GENERAL SAFETY
3
Carefully read these operating and safety instructions before use.
Keep them for future reference.
3
Keep the work area clean, uncluttered and ensure there is
adequate lighting.
3
Maintain correct balance and footing. Ensure the floor is not
slippery and wear non-slip shoes.
3
Remove ill fitting clothing. Remove ties, watches, rings, and other
loose jewellery, and contain and/or tie back long hair.
3
Keep children and unauthorised persons away from the working
area.
7
DO NOT
use the clamp tool for any purpose other than that for
which it is designed.
7
DO NOT
operate the clamp tool when you are tired or under the
influence of alcohol, drugs or intoxicating medication.
p
WARNING!
Ensure Health & Safety, local authority, and general
workshop practice regulations are adhered to when using this
equipment.
1.2
MECHANICAL SAFETY
3
Maintain the clamp tool in good condition.
7
DO NOT
operate the clamp tool if any parts are damaged or
missing as this may cause failure and/or personal injury.
1.3
OPERATIONAL SAFETY
3
When working with the clamp tool you are advised to use
protective equipment including safety shoes, work gloves and
safety goggles.
3
Never insert fingers into the tool.
3. OPERATION
3.1.
The four positions of the pliers are as follows.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
01284 757500
01284 703534
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
www.sealey.co.uk
Web
Position 1
Position 2
Position 3
Position 4
