5.1.
Pre-use Inspection.
WARNING!
INSPECT THE GRINDER BEFORE USE. ENSURE THE GRINDER IS UNPLUGGED FROM THE MAINS POWER
BEFORE COMMENCING THE INSPECTION.
5.1.1. check the tool rests are securely fixed and are not more than 2mm from the grinding wheels.
5.1.2. check that eye shields are in good condition, secure and that you can see through them clearly.
5.1.3. turn the grinding wheels by hand and check for any damage. check they do not touch the tool rests and are correctly aligned.
If any of the above checks fail, replace, repair, or adjust as necessary before starting the grinder.
5.2.
Wheel Use.
the grinder is supplied with two aluminium oxide wheels, one course and one fine. fine is preferred for hard materials and coarse for
soft materials.
If the surface of the wheel becomes “loaded” (coated with particles of the material being ground) it is probably the wrong grade for the
job.
Important reminder:
Only a person holding a grinding wheel certificate may install wheels. See Section 4.
5.3.
Using the Grinder.
WARNING!
before commencing work, ensure you read, understand and apply the Section 1 Safety Instructions.
5.3.1. Plug grinder into the mains power supply.
5.3.2. Adjust the eyeshield to give maximum protection.
5.3.3. switch on the grinder and bring the workpiece slowly into contact with the rotating wheel.
5.3.4. When the task is complete unplug the grinder from the mains power supply and clean the machine ready for next use.
6. MAINTENANCE
WARNING!
Ensure the grinder is unplugged from the mains power supply before performing any maintenance or service.
6.1.
As the grinding wheels wear, adjust the positions of the tool rests. each rest must be set not more than 2mm from the grinding
surface.
6.2.
regularly remove the grinding wheel covers and clean out any dust and dirt.
6.3.
the machine motor and bearings are sealed units and require no regular maintenance. should you require assistance, contact your
local service agent.
5. OPERATING INSTRUCTIONS
noTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
no liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION:
for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park
,
Bury st. edmunds, suffolk,
IP32 7Ar
www.sealey.co.uk
Web
Original Language Version
BG200/99.V2 Issue: 2(l)- 04/03/14
© Jack sealey limited
fitting spark
arrestor
fig. 4
fig. 5
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or telephone 01284 757500.
Environmental Protection.
recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
WEEE Regulations.
dispose of this product at the end of its working life in compliance
with the eu directive on Waste electrical and electronic equipment.
When the product is no longer required, it must be disposed of in an
environmentally protective way. contact your local solid waste
authority for recycling information.
shielded switch
