WARNING!
DO NOT
grind any materials containing asbestos.
8
DO NOT
switch on the grinder whilst the wheel is in contact with the workpiece.
8
DO NOT
get the grinder wet or use in damp or wet locations or areas where there is condensation.
8
DO NOT
use grinder where there are flammable liquids, solids or gases, such as paint solvents and including waste wiping or cleaning
rags etc.
8
DO NOT
touch the workpiece close to the ground surface as it will be very hot. Allow to cool. the workpiece may also be very sharp.
8
DO NOT
operate the grinder when you are tired, under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT
leave the grinder operating unattended.
8
When not in use switch off the grinder, disconnect from the mains power supply and clean the machine and working area
.
2. INTRODuCTION
i
nduction motor drive suitable for general use. Fitted with stone guards, adjustable eye shields and spark arrestors. Substantial tool rests, one
With angled cut-out assisting effective tool sharpening. Variable speed allows for better control of grinding and sharpening. Features integral
c
ooling tray for convenient cooling of sharpened/ground item.
3. SPECIfICATION
m
odel no..:............................................................BG150WVS
supplied with:.............................................................2 stones
m
otor power:..................................................................250W
s
upply:............................................................................230V
A
xle diameter:...............................................................13mm
n
o load speed range:.......................................2000-2800rpm
Weight:......................................................................... 13.8kg
m
odel no:..............................................................BG200WVS
supplied with:.............................................................2 stones
m
otor power:..................................................................550W
s
upply:............................................................................230V
A
xle diameter:............................................................... 16mm
n
o load speed:.................................................2000-2800rpm
W
eight:......................................................................... 17.7kg
4. ASSEMBLy
5. GRINDING WHEELS
5.1.
MANDATORy SAfETy INSTRuCTIONS.
(the following instructions must be observed together with those in section 1).
▲
DANGER
! Use of a damaged wheel (stone) is dangerous and may cause damage and/or personal injury.
WARNING!
ensure grinder is unplugged from mains supply before attempting to change grinding wheel (stone). only
persons qualified
under the “Abrasive Wheels Regulations” and holding a current grinding wheel certificate are authorised to change and dress grinding
wheels (stones).
9
Grinding wheels used with this machine must be of an adequate speed rating and suitable for the material to be ground.
9
Ensure the maximum speed specification of the wheel is higher than that indicated on the machine data plate.
9
Check that grinding wheels are secure and that wheels are not worn or damaged, that there are no fissures or cracks. If damaged
replace immediately.
9
Ensure replacement wheel is not damaged in any way such as cracks, deformations or splinters etc. Also check the mounting flanges
for deformation, burrs or chips. Damaged flanges must not be used as they may produce high stresses in the wheel causing it to
break.
DO NOT
over tighten a wheel. Never tamper with a wheel in order to adapt it to a different size shaft.
fig.1
fig.2
BG150WVS,BG200WVS | Issue 2 28/10/16
Original Language Version
© Jack sealey limited
