2. IntRoductIon
All steel vehicle support stand with pin and chain. full width V-crutch for safe support of load. manufactured to vigorous safety standards. Proven
workshop quality and reliability. sold in pairs.
3. specIfIcatIon
Model no: ................................................................. as2500
capacity each: ........................................ 2.5tonne (2,500 kg)
capacity Pair: ............................................. 5tonne (5,000 kg)
minimum Height: ........................................................ 345mm
maximum Height: ....................................................... 505mm
4. opeRatIon
4.1.
refer to vehicle handbook for correct jacking procedure and points. check to ensure manufacturer’s recommended jacking points are in
good condition.
4.2.
Position stands under recommended strong points and adjust to the required height.
WaRnInG!
IN THE HIGHEST POSITION BOTH ARMS OF THE ‘U’ PIN MUST PASS THROUGH THE UPPER COLUMN -
THERE MUST NEVER BE MORE THAN FOUR HOLES VISIBLE ABOVE THE LOWER COLUMN
(fig.1).
ENSURE THAT THE ‘U’ PIN
HAS PASSED RIGHT THROUGH THE UPPER AND LOWER COLUMN SO THAT BOTH ENDS ARE VISIBLE
(fig.2)
lower the load onto stands carefully and slowly. ensure load bearing points sit in the centres of the stand crutches and that the stands
are stable. Also ensure that there are no objects or persons that could impede the safe lowering of the vehicle onto the stands.
▲
DANGER!
You must follow instructions carefully and
DO NOT
load stand off centre. Failure to heed these warnings may cause damage
and/or injury or loss of life!
5. MaIntenance
5.1.
Before each use, check that stands and stand welds are not cracked and that there are no missing or damaged parts.
5.2.
Any suspect axle stand must be removed from service immediately.
5.3.
owing to the potential hazards associated with stands, do not misuse, or make any modification to, the stands or components.
5.4.
it is the responsibility of the owner to ensure that the operator has read these instructions, together with the safety features on the side of
the stand, and that the operator is familiar with the use and limitations of the stands.
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMpoRtant:
no liability is accepted for incorrect use of this product.
WaRRanty:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar
www.sealey.co.uk
01284 757500
01284 703534
Web
environmental protection
Recycle unwanted materials instead of disposing of them as waste. all tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
fig.1
fig.2
As2500 | issue 6 (sP) 12/01/17
Original Language Version
© Jack sealey limited
