Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
3. CONTENTS
3.1
Carefully unpack the product and check the contents as
detailed in Fig.3. Should any items be missing or damaged
contact your Sealey dealer.
4.1
We recommend that this shelving unit be assembled by two
people. A rubber mallet or a hammer and a piece of wood
can be used to aid assembly.
Do not use a hard faced hammer directly on the beams as
this will damage their surface finish. Make sure that the shelf
support tabs are in line with the leg angle slots. If the tabs
and slots are not lining up do not use force as this may
damage the tabs. If the tabs are out of line bend them slightly
to line up with the slots.
Fig.2
Fig.3
InSTruCTIonS For:
RACKING UNIT WITH 5 SHELVES
MoDEL no's:
AP6500
1. SAFETY INSTRUCTIONS
1.1
GEnErAL SAFETY
W
A
RNING!
Ensure Health & Safety, and local authority
regulations are adhered to when assembling and using these
shelves.
Locate shelves in a suitable area where they will not be an
obstruction.
Keep the general area clean, uncluttered and ensure there is
adequate lighting.
WARNING!
Erect shelves on a level and solid surface such as
concrete.
Keep children and unauthorised persons away from the storage
area.
DO NOT
use the shelves
for any purpose other than that for
which they are designed.
DO NOT
site the shelves out of doors.
DO NOT
get the shelves wet or use in damp or wet locations or
areas where there is condensation.
DO NOT
clean the shelf suports with any solvents which may
damage the coated surface.
Ensure that the shelves are properly assembled before loading
them with heavy items.
Where possible the unit should be fixed to the wall with
suitable fixings
Place heavier items on the lower shelves.
Where possible heavier items should be evenly distributed across
the shelves.
2. INTRODUCTION
4. ASSEMbLY
Fully painted steel frame with five MDF shelves. 500kg Capacity per
level giving a maximum capacity of 2500kg per rack. no nuts and
bolts means no tools required to assemble. Clips together in minutes.
racking can be used as a single bay rack (Fig.1) or split into two
separate shelf systems or workstations (Fig.2).
AP6500
. . . Height: 1800mm . . . Width: 900mm . . . . Depth: 450mm
Fig.1
AP6500 Issue: 1 - 05/06/09
