3 DRAWER MID-BOX CHEST, 5 DRAWER
TOPCHEST, ROLLCAB 8 DRAWER WITH BALL
BEARING SLIDES - BLACK/GREY
MODEL NO’S:
AP3503TB.V2, AP3505TB.V2, AP3508TB.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
toolbox combination.
9
Locate the toolbox combination in a suitable working area.
9
Use on level and solid ground, preferably concrete.
9
Keep the work area clean, uncluttered and ensure that there is adequate lighting.
9
Keep the toolbox combination clean and tidy in accordance with good workshop practice.
9
Keep children and unauthorised persons away from the working area.
8
DO NOT
use the toolbox combination
for any purpose other than that for which it is designed.
8
DO NOT
move the toolbox combination with drawers open. To avoid tipping, open one drawer at a time and close and secure all drawers
whilst moving.
8
DO NOT
overload or step on the drawers.
8
DO NOT
place the toolbox combination in a damp or wet location or an area where there is condensation.
8
DO NOT
clean the toolbox combination with any solvents which may damage the surfaces or the protective coating.
WARNING!
The warnings, cautions and instructions referred to in these instructions cannot cover all possible conditions and situations that
may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied by the
operator.
2. INTRODUCTION
M
anufactured with double skin side walls for extra strength and finished in smooth, hi-gloss, triple baked enamel. Resists scratches, oil, dirt and
most solvents. Smooth ball bearing drawer slides provide superior performance and carry heavier loads. For mobility around the workshop, even
when fully laden, the rollcab features hard compound rubber wheels, two fixed and two locking castors. All drawers have been specifically sized
to accommodate our range of Siegen tool trays. Supplied with two keys.
3. SPECIFICATION
Model No: ........................................................
AP3503TB.V2
W x D x H:
O
verall Size:
............................................
605 x 310 x 275mm
S
mall drawers (3x):
...........................
508 x 268 x 54mm mm
Model No: .........................................................
AP3505TB.V2
O
verall Size:
.....................................
625 x 305 x 470mm mm
S
mall Drawers (5x):
...................................
508 x 268 x 54mm
Model No: .........................................................
AP3508TB.V2
O
verall Size:
............................................
615 x 330 x 885mm
O
verall Size inc. Handle:
.........................
680 x 330 x 885mm
S
mall Drawer (5x):
....................................
508 x 268 x 54mm
L
arge Drawer (x3):
....................................
508 x 268 x 91mm
Refer to
instruction
manual
AP3503TB.V2, AP3505TB.V2, AP3508TB.V2 Issue: 1 (14/01/22
Original Language Version
© Jack Sealey Limited
