5. MainTenance
6. TRouBLeshooTinG
notE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMPoRTanT:
no liability is accepted for incorrect use of this product.
WaRRanTy:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
infoRMaTion:
for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
sole uk distributor, sealey Group,
Kempson Way, suffolk Business Park
,
Bury st. edmunds, suffolk,
IP32 7Ar
www.sealey.co.uk
Web
Original Language Version
5001.V2 Issue: 1 - 04/07/12
fig.2
fig.1
iMPoRTanT:
only fully qualified personnel should attempt
maintenance or repair.
5.1.
Monthly Maintenance
lubrication is critical to jacks, since they support heavy
loads. Any restriction due to dirt or rust can cause either
slow jack movement, or extremely rapid jerks, causing
damage to the internal components. to keep the jack well
lubricated, carry out the following steps:
5.1.1. lubricate the ram, the linkages, the saddle and pump
mechanism with light oil.
5.1.2. Grease the lifting arm, wheel bearings and axles.
5.1.3. Keep all jack surfaces and warning labels clean.
5.1.4. check and maintain the ram oil level (section 5.3).
5.2.
Three Monthly Maintenance
5.2.1. At three monthly intervals, check the ram for any signs of
rust or corrosion. clean the ram as required and wipe with
an oil cloth.
5.3.
checking the oil Level
5.3.1. fully retract the ram by turning the release valve control
knob counter-clockwise.
5.3.2. With the jack in the level position, carefully remove the top
cover.
5.3.3. remove the oil filler plug.
5.3.4. the oil should be level with the bottom of the oil filler hole.
If it is not, top up with clean hydraulic jack oil (sealey Part
no: HJo500Mls or HJo5ls).
5.3.5. replace the oil filler plug and check the jack operation.
5.3.6. Purge air from the hydraulic unit as required (section 3.2).
noTe:
Always store the jack in the fully lowered position. this will
protect critical areas from excessive corrosion.
Important: no rESponSIBILItY IS aCCEptED For
InCorrECt USE oF tHIS proDUCt.
Hydraulic products are only repaired by local service agents. We
have service/repair agents in all parts of the UK.
Do not rEtUrn jaCkS to US.
Please telephone us on 01284 757500 to obtain the address and
phone number of your local agent. If jack is under guarantee you can
also contact your local dealer.
PRoBLeM
cause
ReMedy
Jack will not lift to full height
oil level low
check/top up oil level
Jack will not hold the load
release valve not closing
contact authorised service agent
Hydraulic jack oil is contaminated
Pump valves not sealing
lift arm will not lower
cylinder ram binding
contact authorised service agent
Parts worn
Internal component damage
Broken or unhooked return spring
lift arm linkage either bent or binding
Jack feels spongy when lifting
system requires purging
refer to air purge procedure at section 3.2
Parts support is available for this product. To obtain a parts
listing and/or diagram, please log on to www.sealey.co.uk,
email [email protected] or phone 01284 757500.
© Jack sealey limited 2012
