Installation
Physical Installation
The screen captures below are taken from a Windows 98 installation. Your
particular operating system may differ slightly from what is shown based on
your version of windows.
The
485I
can be connected to any Upstream Type “A” port either at
the PC host or an Upstream Hub. The
485I
is hot-pluggable,
meaning there is no need to power down your computer prior to installation.
The
485I
has an onboard 8 position dip switch that is used to
configure the interface. Prior to connecting the
485I
, be sure to
configure this dip switch for your specific application. Please see the
Configuration section for more information. The
485I
is defaulted to
RS-422 mode so changes are only required if you will be using the product in an
RS-485 application.
1.
After installing the software connect
485I
to an Upstream Host
or Hub.
This indicates that the system has recognized the new device and will now
proceed to locate a driver.
Sealevel Systems
485I
Page
3
