12
left end of the slot. Then remove screw (1) (total 6 pcs), loosen screw (3) (front
two pcs) to drag off the front baseplate (6) and motor safety cover(4). At this
point, the conveyor belt is in a fully loosened state and finally unload conveyor
belt.
9. Starting procedure
1) Connect the power supply and turn startup switch on, the indicating light will
light, then adjust the speed-adjusting knob and all transmission parts will start to
run synchronously.
2) Fine tune the knob of embossing wheel to make that wheel swivel, after getting
a proper pressure, fix limiting screw.
3) Once turn the heating switch on, the green light of the electronic temperature
controller will light. According to the material and thickness of the packing bag,
adjust the temperature controller to the required temperature, then set the
position of ink roller heating knob. Once the heating blocks and ink roller
heating blocks begin to preheat, the machine needs to be started meanwhile
and kept running at low speed.
4) That whether it is necessary to turn on the fan for cooling depends on the
material and thickness of packing bag.
5) Flatten and align sealing opening, then deliver the bag by aligning the bag
opening with the feed opening, when the bag opening is gripped by the sealing
belts, which makes the bag move forward automatically, at that moment, please
do not push it in or pull it out by force, otherwise irregular sealing or breakdown
will happen.
6) If it is found that there is dirt attached to the sealing belt or the heating block,
you need to stop the sealer and clear it.
10. Stop operation
In order to prolong the using life-span of the sealing belt, please remember,
before shutting down the machine, you should return the temperature
regulating knob to position 0 first, then turn on the fan, the temperature on the
indicator begins to fall and the sealing belt should still be in state of running at
this time. About several minutes later, when the temperature drops below 100
℃
,
only can you turn off the fan and main power supply.
11. Emergency stop switch:
At any time, the machine should stop immediately when pressing emergency
stop switch. The emergency stop switch is a self-locking switch, and needs to
rotate clockwise 120 degrees to open it after self-lock.