12
ProSEAL
®
44 Pouch Board Laminator
CLEANING YOUR LAMINATOR
Cleaning the Outside of the Laminator:
CAUTION! Disconnect the laminator from
the power supply before cleaning.
The laminator may be cleaned with a lint-free
cloth, lightly dampened with a mild soap and
water solution. Do not use a spray-on cleaner.
Do not immerse any part of the laminator in
water or other liquid.
Do not use an abrasive cleaner, which can
damage the painted surfaces.
Do not allow water or liquids to enter the
electrical circuits, which may cause personal
injury and/or damage the equipment when
power is applied.
Cleaning the Rollers
The laminating rollers of your ProSEAL should
be periodically cleaned of adhesive build up that
might occur during normal operation.
IMPORTANT! Clean the laminating rollers to
prevent adhesive build-up and to ensure quality
output. Adhesive build-up may eventually
damage the rollers.
When laminating, a small amount of adhesive
will squeeze out between the laminate films and
onto the top and bottom rollers. This residue
accumulates through normal use and can be
easily cleaned off the rollers.
Using a Cleaning Board:
1. A new sheet of 3/16” foam board may be
used to clean the rollers. Simply run the
new board through the machine to
remove any built up adhesive.
1. Turn on the unit. Once the machine has
reached process temperature set the
Control Knob to 3/16" (5mm).
2. Slowly insert the Cleaning Board into the
inlet opening. Ensure that the board
enters centered and straight. A gentle
push may be required to start the board
into the machine. Hold the edges of the
board until it is engaged in the unit and
the laminator begins pulling it on its own.
3. The board will feed through the laminator
and automatically exit at the rear of the
unit.
CAUTION! THE BOARD WILL BE HOT!
Allow the board to lie flat while cooling.
All manuals and user guides at all-guides.com
