4
Installation
1. Place dehumidifier on a level surface.
• Do not place unit directly on vapor barrier. For example, use blocks
or pavers to create a level surface.
• If unit has been turned or flipped so that the compressor did not
remain upright, place the unit on a level surface and wait a
minimum of 2 hours before proceeding.
2. Set up the drain line
• Remove the compression nut and slide it over the end of the hose
to be attached to unit.
• Slide the side of hose with compression nut over the insert on the
compression fitting completely.
• Tighten compression nut.
3. Plug dehumidifier into a dedicated 15 amp GFCI protected outlet.
Key Functions
1. Power Key
• Use this button to turn the dehumidifier on and off.
• Press once to turn machine on. You will hear two beeps and
the light will illuminate green (solid or flashing depending on
mode).
• Press the power button a second time and you will hear one beep
as the machine shuts down. Note that there is a 1 minute fan delay.
2. Arrow Buttons
• Use the up and down arrows to set the desired humidity setpoint
on the display screen.
• The setpoint can be any number between 36%-90%. When the
indoor humidity is higher than the setpoint, the unit will operate.
• Keep in mind that the displayed humidity levels are approximate
( +/-5%)
3. Continuous Mode
• To set the unit to run continuously regardless of humidity,
simply use the down arrow key to set the humidity below 36%.
• The continuous light will illuminate green and the display will show
“CO”.
Summary of Contents for WatchDog NXT120C
Page 14: ...13 Troubleshooting...
