3
www.seagullmodels.com
ADDITIONAL ITEMS REQUIRED.
0.61 - 0.75 2-stroke.
0.91 - 1.00 4-stroke.
Computer radio with 7 servos.
Glow plug to suit engine.
Propeller to suit engine.
Protective foam rubber for radio
system.
Silicone fuel line.
TOOLS & SUPPLIES NEEDED.
Thick cyanoacrylate glue.
30 minute epoxy.
5 minute epoxy.
Hand or electric drill.
Assorted drill bits.
Modelling knife.
Straight edge ruler.
2mm ball driver.
Phillips head screwdriver.
220 grit sandpaper.
90° square or builder’s triangle.
Wire cutters.
Masking tape & T-pins.
Thread-lock.
Paper towels.
SEA14201
Fuselage
SEA14202
Wing Set
SEA14203
Tail Set
SEA14204
Cowling
SEA14205
Main Gear
SEA14206
Nose Gear
SEA14207
Canopy
SEA14208
Decals
SEA14209
Pushrod Set
SEA14210
Wing Tube
SEA14211
Hardware Set
KIT CONTEN.
TS
Hinge.
T-pin.
HINGING THE FLAP .
The control surfaces, including the
ailerons, elevators, and rudder, are
prehinged with hinges installed, but
the hinges are not glued in place. It
is imperative that you properly
adhere the hinges in place per the
steps that follow using a high-quality
thin C/A glue.
Note:
1) Carefully remove the flap from one of
the wing panels. Note the position of the hinges.
2) Remove each hinge from the wing panel
and flap and place a T-pin in the center of each
hinge. Slide each hinge into the aileron until
the T-pin is snug against the aileron. This will
help ensure an equal amount of hinge is on
either side of the hinge line when the flap is
mounted to the wing panel.
3) Slide the flap on the wing panel until
there is only a slight gap. The hinge is now
centered on the wing panel and flap. Remove
the T-pins and snug the flap against the wing
panel. A gap of 1/64” or less should be
maintained between the wing panel and flap.
