EXTRA 330LX
Instruction Manual.
30
2) If all the decals are not precut, please
use scissors or a sharp hobby knife to cut
the decals from the sheet. Please be cer-
tain the model is clean and free from oily
fingerprints and dust. Position decal on
the model where desired, using the pho-
tos on the box and aid in their location.
1) If all the decals are precut and ready to
stick. Please be certain the model is clean
and free from oily fingerprints and dust.
Position decal on the model where de-
sired, using the photos on the box and
aid in their location.
APPLY THE DECALS.
BALANCING.
An important part of preparing the air-
craft for flght is properly balancing the
model.
1. Attach the wing panels to the fuselage.
Make sure to connect the leads from the
aileron to the appropriate leads from the
receiver. Make sure the leads are not ex-
posed outside the fuselage before tight-
ening the wing bolts. Your model should
be flght-ready before balancing.
2. The recommended Center of Grav-
ity (CG) location for your model is
90–
120mm
back from the leading edge at the
wing as shown. Mark the location of the
CG on the top of the wing at the wing tip.
3. When balancing your model, make
sure it is assembled and ready for flght.
Using an assistant, lift the model at the
locations marked in the previous step.
This is the correct balance point for your
model.
90-120mm
Summary of Contents for EXTRA 330LX
Page 3: ...3 ...