Seagull Models CESSNA 188 AGWAGON, Assembly Manual

Page: 27 / 40

27
7) When you are sure that everything is
aligned correctly, mix up a generous amount
of 30 Minute Epoxy. Apply a thin layer to the
top and bottom of the stabilizer mounting
area and to the stabilizer mounting platform
sides in the fuselage. Slide the stabilizer in
place and realign. Double check all of your
measurements once more before the epoxy
cures. Hold the stabilizer in place with T-pins
or masking tape and remove any excess epoxy
using a paper towel and rubbing alcohol.
Fill Epoxy.
HINGING THE RUDDER.
Glue the top two rudder hinges in place
using the same techniques used to hinge
the ailerons.
The lower hinge will be glued when the
fin/rudder assembly is attached to the fu-
selage.
INSTALL RUDDER CONTROL HORN.
Repeat steps to install the rudder con-
trol horn as same as steps done for ailer-
ons.
Epoxy.
Epoxy.
Fill Epoxy.