11
www.seagullmodels.com
Mark and drill 4 holes for engine mount.
Insert 4 blind nuts to firewall.
See pictures below.Make yourself the
template of your engine on paper.
ENGINE MOUNT INSTALLATION.
M4x30mm.
INSTALLING THE STOPPER ASSEMBLY.
1) Using a modeling knife, carefully cut off
the rear portion of one of the 3 nylon tubes
leaving 1/2” protruding from the rear of the
stopper. This will be the fuel pick up tube.
M4x30mm.
Fuel Fill Tube.
Vent tube.
Fuel Pick up
Tube.
3) Carefully bend the second nylon tube up
at a 45º angle. This tube is the vent tube.
2) Using a modeling knife, cut one length of
silicon fuel line. Connect one end of the line to
the weighted fuel pick up and the other end to
the nylon pick up tube.
4) Carefully heat the vent tube using a
heat gun or lighter to permanently set the
angle of the tube.
1
5) Test fit the stopper assembly into the
tank. It may be necessary to remove some of
the flashing around the tank opening using a
modeling knife. If flashing is present, make
sure none falls into the tank.
When the stopper assembly is in-
stalled in the tank, the top of the vent tube
should rest just below the top surface of
the tank. It should not touch the top of the
tank.
