Seagate Mobile HDD Product Manual, Rev. A
32
Serial ATA (SATA) Interface
6.0
Serial ATA (SATA) Interface
These drives use the industry-standard Serial ATA interface that supports FIS data transfers. It supports ATA programmed input/output (PIO) modes
0–4; multiword DMA modes 0–2, and Ultra DMA modes 0–6. The drive also supports the use of the IORDY signal to provide reliable high-speed data
transfers.
For detailed information about the Serial ATA interface, refer to the
Serial ATA: High Speed Serialized AT Attachment
specification.
6.1
Hot-Plug Compatibility
Attachment specification revision 2.0. This specification can be downloaded from
www.serialata.org
. This device requires a COMRESET from the
host after a hotplug event.
6.2
Serial ATA Device Plug Connector Pin Definitions
summarizes the signals on the Serial ATA interface and power connectors. Refer to the
below.
Notes
1
All pins are in a single row, with a 1.27 mm (0.050 in) pitch.
2
The comments on the mating sequence apply to the case of backplane blindmate connector only. In this case, the mating sequences are:
• the ground pins P4 and P12.
• the pre-charge power pins and the other ground pins.
• the signal pins and the rest of the power pins.
3
There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate backplane
configuration.
4
All used voltage pins (V
x
) must be terminated.
Table 13 Serial ATA Connector Pin Definitions
Segment
Pin
Function
Definition
Signal
S1
Ground
2nd mate
S2
A+
Differential signal pair A from Phy
S3
A-
S4
Ground
2nd mate
S5
B-
Differential signal pair B from Phy
S6
B+
S7
Ground
2nd mate
Key and spacing separate signal and power segments
Power
P1
V33
3.3V power
P2
V33
3.3V power
P3
V33
3.3V power, pre-charge, 2nd mate
P4
Ground
1st mate
P5
Ground
2nd mate
P6
Ground
2nd mate
P7
V5
5V power, pre-charge, 2nd mate
P8
V5
5V power
P9
V5
5V power
P10
Ground
2nd mate
P11
Ground or LED signal
If grounded, drive does not use deferred spin
P12
Ground
1st mate
P13
V12
12V power, pre-charge, 2nd mate
P14
V12
12V power
P15
V12
12V power