Seagate IronWolf Pro ST2000NE001, Product Manual

Page: 11 / 37

Seagate IronWolf Pro SATA Product Manual, Rev. J 10
2.5 Power specifications
The drive receives DC power (+5V or +12V) through a native SATA power connector. See Figure 5 on page 25 .
2.5.1 Power consumption
Power requirements for the drives are listed in Table 2 through Table 3 . Typical power measurements are based on an average of
drives tested, under nominal conditions, using 5.0V and 12.0V input voltage at 25°C ambient temperature.
Table 2 DC power requirements (8TB & 6TB)
6.0Gb mode
Voltage +5V +12V Watts
Regulation ± 5% Total
Avg Idle Current * 0.227 0.497 7.06
Advanced Idle Current *
Idle_A 0.226 0.497 7.06
Idle_B 0.173 0.426 5.90
Idle_C 0.166 0.226 3.53
Standby 0.158 0.01 0.86
Maximum Start Current
DC (peak DC) 0.702 1.65 23.34
AC (Peak DC) 0.968 1.96
Operating current (random read 4K16Q)
Typical DC 0.393 0.705 10.36
Maximum DC 0.396 0.717
Maximum DC (peak) 0.11 2.25
Operating current (random write 4K16Q)
Typical DC 0.27 0.798 10.86
Maximum DC 0.27 0.805
Maximum DC (peak) 0.636 2.24
Operating current (sequential read 64K16Q)
Typical DC 0.696 0.544 9.94
Maximum DC 0.701 0.546
Maximum DC (peak) 1.23 1.82
Operating current (sequential write 64K16Q)
Typical DC 0.593 0.539 9.37
Maximum DC 0.593 0.539
Maximum DC (peak) 0.704 0.853