49
Engine Coolant Level
Ensure coolant level is appropriate as
specified in LIQUIDS section. Check
for coolant leaks on engine, in bilge and
from ride plate.
Steering System
Assisted by another person, check
steering operation for free movement.
When the handlebar is horizontal, the jet
pump nozzle should be in the straight
ahead position. The rear edge of side
vanes should be pointing outside of wa-
tercraft by 20°. Ensure the jet pump
nozzle and side vanes pivot easily and in
the same direction as the handlebar.
Throttle System
Check throttle lever for free and smooth
operation. It should return to its initial
position immediately after it is released.
Shifter System
Check reverse gate operation for free
movement. With shift lever in forward
position, the gate should be in upward
position; and offering a resistance to go
downward. With the shift lever in neutral
position, gate should be in middle posi-
tion. With shift lever in reverse position,
gate should be in downward position.
Storage Compartment
Covers and Seat
Ensure they are closed and latched.
Safety Lanyard and Engine
Start/Stop Button
Position shift lever in neutral. Ensure that
both switches operate properly. Start en-
gine and stop it using each switch indi-
vidually.
WARNING
When operating the engine while
the watercraft is out of the water,
the heat exchanger in the ride
plate may become very hot. Avoid
any contact with ride plate as
burns may occur.
WARNING
Check handlebar and correspond-
ing steering nozzle operation be-
fore starting. Never turn handle-
bar while someone is nearby rear
of watercraft. Keep away from
steering moving parts (nozzle,
side vanes, linkage etc.).
WARNING
Check throttle lever operation be-
fore starting the engine.
WARNING
Verify the reverse gate operation
before starting the engine.
WARNING
Make sure seat is securely latched.
WARNING
Should the safety lanyard cap is
loose or fail to remain on its post,
replace it immediately in order to
avoid unsafe use.
smo2002-003_a.book Page 49 Friday, October 12, 2001 2:04 PM