INTRODUCTION
– Spray Loctite Primer N on both mating surfaces
and on both sides of gasket. Allow to dry 1 or
2 minutes.
– Apply GASKET ELIMINATOR 518 (P/N 293 800
038) on both sides of gasket, using a clean ap-
plicator.
– Place gasket on mating surfaces and assemble
immediately.
NOTE:
If the cover is bolted to blind holes (above),
apply proper strength Loctite in the hole and on
threads. Tighten.
If holes are sunken, apply proper strength Loctite
on bolt threads.
– Tighten as usual.
Mounting on Shaft
Mounting with a Press
A00A3UA
1
2
3
1. Bearing
2. Proper strength Loctite
3. Shaft
Standard
1. Clean shaft external part and element internal
part.
2. Apply a strip of proper strength Loctite on
shaft circumference at insert or engagement
point.
NOTE:
Retaining compound is always forced out
when applied on shaft.
– DO NOT use antiseize Loctite or any similar
product.
– No curing period is required.
Mounting in Tandem
– Apply retaining compound on internal element
bore.
– Continue to assemble as shown above.
Case-In Components
Metallic Gaskets
A00A3VA
1
1. Proper strength Loctite
– Clean inner housing diameter and outer gasket
diameter.
– Spray housing and gasket with Loctite Primer N
(P/N 293 800 041).
– Apply a strip of proper strength Loctite on lead-
ing edge of outer metallic gasket diameter.
NOTE:
Any Loctite product can be used here. A
low strength liquid is recommended as normal
strength and gap are required.
– Install according to standard procedure.
– Wipe off surplus.
– Allow it to cure for 30 minutes.
NOTE:
Normally used on worn-out housings to
prevent leaking or sliding.
It is generally not necessary to remove gasket
compound applied on outer gasket diameter.
TIGHTENING TORQUES
Tighten fasteners to torque mentioned in explod-
ed views and/or text, When they are not specified,
refer to following table.
WARNING
Torque
wrench
tightening
specifications
must strictly be adhered to.
Locking de-
vices (e.g.: locking tabs, elastic stop nuts,
self-locking fasteners, etc.) must be installed
or replaced with new ones, where specified.
If the efficiency of a locking device is im-
paired, it must be renewed.
smr2005-041
XVII
www.SeaDooManuals.net
Summary of Contents for 105A
