G24 HDMI User Guide
5.
Command Lines
All the ASCII commands given in this section use the following RS232 port settings:
•
Baud Rate: 57600
•
Data Bits: 8
•
Parity: None
•
Stop Bits: 1
All the ASCII RS232 commands given in this section can also be sent to the LAN port using the
following settings:
•
Default IP Address: 192.168.0.247
•
Default Network Mask: 255.255.255.0
•
Default Gateway: 192.168.0.1
•
Port: 23
Notes:
•
All commands in this section are always terminated with the ASCII carriage-return character,
0x0d. This is represented by the symbol in each command.
•
All responses are always terminated with the ASCII carriage-return and line-feed sequence
(0x0d 0x0a).
•
All spaces shown in the command are required. Lowercase letters are used as value
placement indicators, the required value or identifier is given in the Details panel for each
command.
5.1.
Recall/Save Preset Layouts of Video Wall
Operation
type
(3 byte)
Spacer
(1 byte)
Target
(N bytes)
Spacer
(1 byte)
Command
type
(10 bytes)
Command
parameters
(1/2/3 bytes)
Command tail
(1 byte)
SET/GET
Space
SYS
Space
ROUTE-
MODE
x/xx/xxx
x is the mode
value
This is ASCII
carriage return
0x0d
A.
GET (Recall) the route mode saved before:
For example, GET (Recall) the video wall preset layout 1
Send:
GET SYS ROUTE-MODE 1
Receive:
SYS ROUTE-MODE 1
B.
SET (Save) current route to a mode:
For example: SET (Save) current layout to preset layout 1
Send:
SET SYS ROUTE-MODE 1
Receive:
SYS ROUTE-MODE 1
