Sea Ulcer SKY RIGGER, User Manual

Page: 8 / 20

8
Video guides are available at www.seaulcer.com
There are several ways to mount SKY RIGGER on your drone. The Drone Mount can be installed on its horizontal or vertical
legs, or an adhesive pad can be stuck to the belly of your drone – visit www.seaulcer.com for drone compatibility and further
instructions on how to mount.
These are the easiest steps to install the Drone Mount in the recommended location – on the horizontal feet:
1. Use the ‘fish’ hex tool to loosen the Drone Mount leg clamps (see page 9).
2. Loosely attach one of the clamps to one foot of the drone (ensuring the release mechanism swings away from the camera
and the arch is facing towards the belly of the drone), and then swivel it diagonally, so you are able to slip the other leg clamp
onto the drone.
3. With the Drone Mount in a ‘straight’ position, tighten the clamps using your fish hex key. If required, adjust the width of
the SKY RIGGER by loosening the grub screws, adjusting, and re-tightening firmly.
4. Ensure each of the SKY RIGGER’S six screws are finger tight.
To install the Drone Mount in vertical position, first remove the leg clamps by loosening their cap screws, and disconnect them
from the main arm. Reattach the clamps at a 90-degree angle to their original position, and then attach the Drone Mount to
the ‘rear’ vertical legs of the drone using the method described above.
Mounting your SKY RIGGER