Sea Tel 3011W-91, Installation Manual

Page: 27 / 147

3011W-91 Installation Manual Installation
3-8
3. To un-restrain the elevation axis of the
antenna, unthread the two hex nuts. Remove
the hex nuts and washer from the stow pin-
bolt.
4. Remove the stow pin-bolt from the bracket.
5. Remove the washer from the stow pin-bolt
and thread one of the 2 hex nuts onto the
bolt and tighten.
6. Put one of the washers onto the stow pin-bolt
and insert it into the bracket toward the
elevation pan.
7. Put the other washer, and then the other hex
nut, onto the bolt.
8. Tighten the hex nut to prevent the hardware
from loosening while in the un-stowed
configuration.
9. Verify that the antenna rotates freely and
easily through its full elevation range of
motion.
3.4.3. Removing the CL Shipping/Stow Restraint
1. The CL Shipping/Stow restraint is formed by a
red locking bar with adjustable bumpers at
each end of the bar. This mechanism is
placed under the cross-level beam to lock it in
place.
Cross-Level Beam
CL Shipping/Stow bar
Adjustable CL Locking Bumpers (only one end shown)