Raise fan with downrod assembled to the ceil-
ing bracket and hang fan assembly. Be sure to
rotate the downrod ball so that the notch in the
bracket engages the slot in the ball.
8
Attach blade brackets to blades using the blade
bracket screws and washers provided.
12
Remote receiver
Motor
Make wire connections as per diagram in fig.
11. Connect the white wire from the Receiver
to the White or Neutral wire from the power
source. Connect the black wire from the
Receiver to the Black wire from the wall trans-
mitter. Connect all Green / Yellow wires from
the fan, Downrod and mounting bracket to the
Ground wire from the house. Connect White (to
motor) to White from fan, Connect Black (to
motor) to Black from fan marked , Connect Blue
(to light) to Blue from fan“light kit”, Connect
Gray from remote to gray from fan and Purple
from remote to Purple from fan.
Connect one black wire from Transmitter to wire
from house wiring leading to the black wire on
receiver. Connect the other black wire from the
transmitter to black or hot wire from the power
source. Connect green wire from wall transmit-
ter to ground. Warning: Make sure that all
filiments are inside the wire nut connector.
11
House
Fan
White
Black
White
7
Before attaching blades; remove the switch housing.
Install remote receiver by sliding into opening in
the Mounting bracket. Make sure that the dip
switches on the Transmitter and the Receiver
are set to the same position. See Fig 23 for
remote operation
10
Check the motor for plastic shipping stabilizer
tabs, and remove them if they are present. The
screws, washers and motor pads are pre-
installed to the blade holders. Attach blade
assembly to motor and tighten screws securely.
13
14
After attaching blades; install the switch housing
using the three screws previously removed.
Lift Canopy to ceiling aligning the key hole slots
with the screws on the bottom of the Mounting
bracket. Rotate the canopy Counter Clockwise
to lock in place. Tighten the screws to secure
the Canopy. See inset for Keyhole shape
15
Black (to motor)
Blue (to Light)
Gray
Purple
White (to motor)
Black
Blue
Gray
Purple
Make wiring connection to fan by mating plug
from fan with plug from light kit.
16
Set dip switches on the Remote Transmitter and
Remote Receiver to the same settings. This
must be done so the units will communicate
properly. If you have other fans you can set to
control from one transmitter by setting both
receivers the same as the transmitter. If you
have more than one fan with remote. You can
set the dip switches to different positions to
have seperate control.
Remote Transmitter Dip
switches
Remote Receiver Dip
switches
located on top of fan
9
Tr
ansmitter
