9
Bolt the raised oarlock
bases at both ends of the
aluminum bench through
the pre-drilled 3/8” holes
(2 at each end) using
knurled nuts
Slide the oarlock pin over
the shaft of the oars, snap
the oars shafts together
and then insert the oarlock
pin into the top of the
oarlock. Tighten the clamp
with the wingnut.
Once the oar pins are
inserted place, lock them
in place using the slide
rings as shown.
375FC Motormount
Includes a motor mount
block, two brackets, four
bolts, knurled knobs and
washers.
Secure the brackets to the
motor mount block using
one set of bolts. Orient the
block so it hangs about
1/2” below the floorboard.
Then use the remaining
bolts to secure the mount
to the floorboard.
To prevent cavitation
when using a short shaft
gas motor. The completed
setup should hang slightly
below the floorboard,
as shown. Tighten the
knurled nuts and bolts
before securing a motor.
Casting Bar ( OPTIONAL)
Adds safe and secure
support for stand-up
casting and doubles as
a convenient hand-hold
while stepping aboard.
Includes crossbar with
padded cover, two
upright leg bases, and two
4mm hex keys (one spare).
Insert the uprights into the
crossbar. The height of the
casting bar can be
adjusted to one of three
positions using the
pre-drilled holes on the
uprights.
ASSEMBLY & INFLATION
