《
Power button
》
Use the power button to turn ON / OFF
the 1G camera.
《
Shutter lever
》
Depress the shutter lever to press the
shutter release button of the 1G camera.
《
Mode dial
》
Turning this dial changes the shooting
mode. Mode setting status is displayed at
the top center of the LCD monitor of the
1G camera.
《
Up-down dial
》
Turning this dial rotates the up-down dial
on the 1G camera. Use this dial to work
with the menu and to change aperture or
setting value quickly and easily.
《
ADJ. dial
》
Pushing and flicking this dial to the right
and left operates the ADJ. lever of the
1G camera.
《
Other buttons
》
Use buttons to control each function of
the 1G camera underwater.
Operation
7
8
Up-down dial
Mode dial
ADJ. dial
Power button
Shutter lever
Flash OPEN switch
Other buttons
1
．
Install the 1G camera to the housing as shown
in Fig.1.
2. Make sure that there is not dust or scratches
on the O-ring / O-ring mating surface before
closing the rear cover. Take the hand strap
out, press the rear cover, and then put the
buckle over the front case (Fig.2).
3. Push the buckle down until it clicks. Make
sure that the red buckle lock buttons on both
sides are popped out (Fig.3).
●
Please refer to the instruction manual of the 1G camera for operation
of the other buttons.
Click
●
To avoid flooding by trapping, remove the
wrist strap from 1G camera before installation
(Fig.4).
●
Never install or remove the 1G camera while
the camera is ON. The ejected lens may
interfere with the housing and damage the
camera and lens.
●
Make sure that the 1G camera is set parallel
to the housing and not excessively slanted.
●
The built-in flash of the 1G camera does not
fire if the flash cover is not opened.
●
Before installing the 1G camera, slide the
Flash OPEN switch to the outside to raise
the flash cover, open the flash, and remove
the lens cap from the camera. Turn off the
power of the camera before installation.
Installing the 1G Camera
Fig.1
Fig.4
Fig.2
Fig.3
！
CAUTION
！
CAUTION
