AC Power Light
Will be lit when the SK-195 AC/DC
Power Supply is supplying power to
the Alarm Center.
Low Battery Light
Will )))flash((( when batteries
should be replaced.
Will )))flash((( if no batteries are
installed and the AC power is on.
Key Disarm Light
Will be lit when the Alarm Center is
Disarmed using the Key-Lock.
Keypad Disarm Light
Will be lit when the Alarm Center is
Disarmed using the Key-Lock.
Circuit “A” Light &
Circuit “B” Light
Will be lit if a Termination
“End Plug” is not installed.
Will )))flash((( if an alarm has
been caused on that circuit.
Will not be lit when all
sensors and the Termination
“End Plug” have been
properly installed.
Keypad Program Light
Will be lit when the Alarm
Center is in the keypad
programming mode and
ready to accept a new code.
2.
Installation:
The ME Jr. plus 2 Control Module has (2) circuits; one marked Circuit “A” and one marked
Circuit “B”. Any combination of up to (10) Splitters/Strips can be Daisy-Chained to the
Control Module as long as the total number from both circuits Does Not Exceed (10). If all
(10) Splitters/Strips are chained to a single circuit, an “End Plug” must be installed in the
other circuit. An “End Plug” must also be installed in the last splitter of each chain.
Special Note: Place the ME Jr. plus 2 in the Key Disarm Mode to install splitters and sen-
sors. The Key Disarm Mode prevents the unit from Automatically Arming after (4) minutes.
• After arranging display, connect Splitters/Strips together using the 6 ft.
(SK-847) cables (provided with each splitter).
If specific lenth cables is required: you may order them using Part No.
(SK-847-x), where x = the length of the cable in feet.
• Connect an ME Jr. Sensor to a port on the Splitter/Strip and to the corresponding display product.
Selecting Sensors for Display Product: (Sensors are available in Straight (P/LE) & Coiled (PC/LE).
SK-809
Telephone Modular “End Plug”
SK-847-x
(x = Cable Length in Feet)
Extension (Connects Alarm Module
to Splitters & Splitters to Splitters)
SK-902
1" x 1" Bug Sensor
SK-943
Tie Sensor
SK-961
Ant Sensor
Other Straight,
Coiled &
Dual Sensors
Are
Available.
Ask Your
Customer Service
Representative
For Details.
SK-904
1" x 2" Rectangular
Sensor
SK-927
Parallel Port Sensor
SK-953
collar Lasso Sensor
SK-955
Slim-Line Sensor
SK-968
Mini Phone Sensor
SK-990
Bendable Label
Sensor
)
)
)
SK-HORN
Remote Horn
SK-800KME
ME Jr. plus 2 Alarm Module
SK-80108ME
8 Port KE Strip
SK-807ME
8 Large Port KE Splitter Box
SK-195
AC/DC Power Supply