3
1.0 Important Notices
•
Use of abrasive or solvent cleaning products may damage the panel
•
Taken care when fault finding or servicing to retain device addresses.
2.0 Parts
The SHEVTEC® Repeater Panel comprises:
•
SHEVTEC® Repeater Panel
•
Mounting Plate
•
Torx locking screw
Not supplied but required:
•
Installation of one or more OS2 OSLink or OSLoop Coordinator
•
Four core fire rated cable
•
Wall fixings and screws
3.0 Tools Required
•
Drill for wall fixings
•
Spirit level
•
Screwdriver
•
Wire cutters and strippers
•
Torx screwdriver
•
Optional multimeter
OSLoop systems require the parameter [OADD] set – this may be preset at the factory or may require use of an
SEC POP configuration tool.
4.0 Preparation
SHEVTEC® Repeater Panels are custom built for each application. After unpacking the SHEVTEC® Repeater Panel
and check the reference printed on the data badge is correct.
5.0 Cable installation
Install a four-way fire rated cable between the nearest OS2 or OSLoop Coordinator and the required location of
the panel. Where cables are buried in the wall, ensure the wall is flat over the area of the panel and that the cable
is brought to the centre of the desired location. Leave 200-300mm spare cable at the repeater.
