18
3.
-
OPENING AND CONTROL
Carefully open the package, check the content and make sure that all the parts are present
and are in good condition. In cases where some parts are not present or are damaged,
immediately contact Your supplier and retain the packaging for verification.
WARNING!
If the product has been exposed to drastic temperature changes, let
the unit turned off until it reaches room temperature because the
presence of condensation can damage the product if it is turned on.
Verify that the box contains the following items:
N° 1
SG FASTER192
N° 1
Power supply unit
N° 1
User Manual
4. – INSTALLATION, SWITCH ON AND USE
INSTALLATION
Install the device on a plane surface or install it in a rack.
Rack installation: this device is built for 3
-
units rack (483 mm). The rack you use should be a
double door rack where you can open the front panel and the rear panel. The rack should be
provided with a cooling fan. When mounting the device into the rack, please make sure that
there is enough space around the device, so that the hot air can be passed on. Steady
overheating will damage your device. You can fix the controller with four screws M6 in the
rack.
Connect the connection cable of the power unit with the DC in socket. Plug the power unit
into your outlet.
SOUND CONTROL
The sound control works via built
-
in microphone or via the Line
-
in socket. Connect the sound
signal from the mixer with the RCA socket on the rear panel (input sensitivity 0,1V – 1V).
DMX
-
512 CONNECTION WITH THE PROJECTORS
The wires must not come into contact with each other, otherwise the fixtures will not work at
all, or will not work properly.
Only use a stereo shielded cable and 3
-
pin XLR plugs and connectors, in order to connect the
controller with the fixture or one fixture with another.