P:\INSTALLATION INST\ACCESS CONTROLS\E75\INST-E75.vsd REV F 03-20 Page 2
Install the Keypad and
Battery pack to the door
Pass a small pull wire through the
raceway hole. This pull wire will
be used to bring wires from the
lockset hole to the keypad wiring
area.
Pull
Wire
Install the Lockset.
(Refer to lockset
instructions)
Attach the Pull Wire to the
Cylindrical Lock Wires. Pull the
lock wires up through the raceway
as you insert the cylindrical lock.
Pull Wire
Cylindrical
Lock Wires
Attach wires from the lockset to the keypad
using the chart to the right.
Specifications
Power
4AA Batteries (Alkaline only) or
External 12VDC Power @ 30mA
Inputs
1 Request-To-Exit
1 Door Position Switch
Output
SPDT Contacts 1A @ 30VDC Relay
Temperature
-20 F to +130 F (-30 C to +54 C)
Humidity
5% to 95% non-condensing
Latch Bolt
9/16”
Backset
2-3/4”
Strike
4-7/8” ANSI A115.2
Door
1-3/4” to 2-1/8”
Thickness
Additional Wire Connections (Optional)
Request-To-Exit Input
Door Position Switch Input
Auxiliary Relay Output
System Reset
= BLU(N/O) / BLK(COM)
= GRY / BLK(COM)
= ORG (N/C)
WHT(COM)
YEL(N/O)
= BRN / BRN
2
3
4
5
6
7
From
Keypad
From
Lockset
RED
WHT
RED
WHT
Function
Motor
Output
+
_
NOTE: Use E75-TOOL to remove back cover
to replace batteries.
12VDC External Power
(NOTE: Ext. pwr harness
ships separately in box)
= RED(+) / BLK(-) (22AWG)
Keypad
Wiring
area
FOR E75KL or E75PL Privacy Locks, skip to Steps 8-10 on the next page.
For all other models, follow Steps 5-7 below.
Gasket
Apply power by plugging
in the keypad’s 2-wire connector
to the battery pack connector.
The left LED will flash rapidly as
shown below followed by 3
beeps.
Replace the cover over the battery pack by first
hooking the top and gently pressing the bottom
