Precision Pro - Page 25
Model: Precision 5500-M
Precision 2200-M
1- Tach wire must be connected , The system must learn RPM.
2- Hand brake must be connected.
3- Door trigger must be connected
4- Clutch override installed NOTE: MUST USE RELAY, SEE PAGE 28.
Remote Starting
With engine running and Hand-brake engaged put the vehicle transmission in neutral and remove the
foot from the brake pedal, press the remote start button on your transmitter, parking lights will flash
twice indicating Manual Start Mode is enabled, turn off the Ignition switch, the engine will remain
running. Open and close the door, the system will shut the engine Off. Using the remote Control,
Arm*/Lock the vehicle. Vehicle is now ready for remote start operation.
Starter Ready Mode is canceled any time the door is opened; hand brake is released or any
other error condition.
To Remote Start the System:
1. Be sure the system is not in Valet Mode.
2. Press and hold Button 4 for three seconds.
· The parking lights will turn on.
· The LED will flash rapidly.
· The engine will start and run for the duration of its programmed Run Time.**
· The heater or air conditioner will turn on (if turned on prior to exiting the vehicle).
**If the engine fails to start on the first attempt, it will repeat the starting procedure 2 more times. If the vehicle
fails to start after a total of 3 times the parking lights will flash 4 times and the doors will lock (if installed).
Turn on the ignition and press the brake pedal to disengage the remote start feature and drive the vehicle.
Shut Down
When the the Remote Start feature is active, any of the following actions will shutdown the engine:
1. Pressing Button 4.
· After the engine shuts down the doors will lock (if installed).
2. Pressing the Brake Pedal.
3. Opening the Hood.
4. Remote Start Time-Out (completion of the timed run cycle).
5. Emergency Brake Off.
Turbo Timer Inhibit
With the engine running, apply the parking brake then push the remote start button on the transmitter,
lights will flash twice. Turn off the ignition, the engine will stay running. Now push and release the the
push button switch, the siren will chirp once. The Turbo Timer feature is now canceled. Open and close
the door, engine will shut down. Vehicle is now ready for remote start.
Manual Transmission Remote Start Features
Summary of Contents for PRECISION PRO 2200
Page 4: ......
