Precision 700 - Page 7
Adding/Replacing One-Way Transmitters
To replace lost or stolen transmitters or to add additional transmitters into the system, have all
desired transmitters ready and follow the steps below.
Note
: Up to 4 transmitters can be programmed to operate the system. To erase any previously
stored transmitter codes, be sure to program all 4 transmitter memory locations.
To program the transmitter(s):
1. Turn on the ignition key On, Off, On, Off, and back On.
· The siren will chirp 3 times.
2. Press and hold the Override switch for 5 seconds.
· The siren will chirp 5 times.
· The LED will illuminate.
3. Press Button 1 on the first transmitter.
· The siren will chirp once.
4. Press Button 1 on the first transmitter again.
· The siren will chirp twice to indicate it has learned the code.
5. Repeat steps 3 and 4 for each transmitter (up to 4).
6. Turn off the ignition key.
Two Car Operation (non LCD transmitter only)
If two vehicles are equipped with Precision 700 systems, for convenience both can be operated
using the same remote transmitter. If all four transmitters are to be used with both cars,
program transmitters A and B into the first vehicle in the manner described above. Program
transmitters C and D by pressing the Shift button twice before performing steps 3 and 4 above.
When finished programming the first vehicle, program transmitters C and D into the second
vehicle as normal, then program transmitters A and B by pressing the Shift button twice before
performing steps 3 and 4 above.
When programmed in this manner, the driver of the first car can also operate the second vehicle
by pressing the Shift button twice and the desired function button.
Battery Replacement
Your Remote Transmitter uses two 3 volt lithium batteries (type CR2016), which will require
replacement in time. Depending on the amount of use, the batteries may last up to six months
or more before they need replacement.
When the battery needs replacing, the system’s operating range will decrease or the transmitter
LED may not be as bright.
In order to change the batteries, first remove the screw from the back of the transmitter and
separate the top and bottom halves of the case.
While replacing the batteries make sure that the positive and negative terminals are positioned
correctly, then carefully reassemble the transmitter case.
