SCT RemoteCam5, Quick Install, Page: 2 / 2

www.soundcontrol.net 203-854-5701 ©SOUND CONTROL TECHNOLOGIES, INC. 2015
The cable
must be wired for either UTP 568A or UTP 568B. For your convenience, you can use the
above scheme.
To install the RemoteCam5™ Kit, follow this step-by-step guide:

Step 1

Test and verify the Cat5e or Cat6 cable for UTP 568A or 568B wiring: See steps 2 & 3.

Step 2

Install the RC5-HE Head-End Module at the rack/equipment location.

Connect the Cat5e or Cat6 cable only to the RC5-HE module.

Connect the power supply to the RC5-HE Module.

Step 3

Using the PowerSniffer™, at the Camera Location connect to the UTP cable. When properly
terminated the PowerSniffer™ will display 8 green LED’s.

Any other result, please re-terminate.

Step 4

Disconnect the power supply from the RC5-HE

Step 5

Connect the CAT5e or CAT6 cable to the RC5-CE Camera Module.

Step 6

Connect provided cables between codec and RC5-HE module.

Step 7

Connect provided cables between camera and RC5-CE module.

Step 8

Connect the power supply to RC5-HE module

LED Behavior:

Head-End Module HDCP LED: Blinking = HDCP Inactive, Solid = HDCP Active

Head-End Module Link LED: Blinking Red = No Link, Blinking Red to Green = Link Active

Camera Module: LED will be Red until Link is established, Solid Green when Link is Active

Step 9

Enjoy!