www.soundcontrol.net
203-854-5701
©SOUND CONTROL TECHNOLOGIES, INC. 2017
To proceed with the installation, insure that you have installed one CAT5e or CAT6 cable between the
camera installation site and the codec installation site.
Minimum distance should be approximately 30’/9M.
The cable
must
be wired for either UTP 568A or UTP 568B. Please use the following scheme:
To install the RemoteCam4™ Kit, follow this step-by-step guide:
•
Step 1
•
Test and verify the Cat5e or Cat6 cable for UTP 568A or 568B wiring.
•
Step 2
•
Install the RC4-HE Head-End Module at the rack/equipment location.
•
Connect the Cat5e or Cat6 cable to the RJ45 connector labelled on the RC4-HE module.
•
Connect the power supply to the RC4-HE Module.
•
Wait to connect the cable to the RC4-CE until steps 3 & 4 are completed.
•
Step 3
At the camera location
connect the PowerSniffer™ to the CAT5e or CAT6 cable.
If the cable is properly terminated it will display 8 green LEDs. See Image at left.
Any other result, please re-terminate.
•
Step 4
•
Disconnect the power supply from the RC4-HE
•
Step 5
•
Connect the CAT5e or CAT6 cable to the RJ45 connector labelled on the RC4-CE Camera Module.
•
Step 6
•
Connect provided cables between codec and RC4-HE module.
•
Step 7
•
Connect provided cables between camera and RC4-CE module.
•
Visca
•
The Visca loop, or daisy chain, supports up to seven cameras. On supported applications SCT supplies a
Visca Out cable. This cable should be connected from the camera to the RC4-CE
only
when there is a
proceeding camera in the daisy chain. Utilizing this cable on the last camera in the chain will terminate
control of all cameras.
•
Step 8
•
Connect the power supply to the RC4-HE module
•
LED Behavior:
•
Head-End Module HDCP LED:
Blinking = HDCP Inactive, Solid = HDCP Active
•
Head-End Module LED:
Blinking Red = No Link, Blinking
Red
to
Green
= Active
•
Camera Module:
LED will be
Red
until Link is established, Solid
Green
when is Active
•
Step 9
•
Enjoy!
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
