12
After the receivers and transmitter you want to keep RS232 connection established then press IR
remote button
MENU, 2, 8, ENTER
to enable RS232 assign mode.
★
If you switch to a not available channel the RS232 connection will be cut and lose control, the RX
will switch back to assigned channel after 3 seconds automatically to keep RS232 connection
★
If IP address of transmitter has been changed you have to enable RS232 assign mode for
recovers again.
To disable RS232 assign mode press IR remote button
MENU, 2, 9, ENTER
RS-232 Control command
：
(Not available for HE05BER)
User could use RS-232 port of transmitters to operate/setup the receivers at same channel by
program like Hyper Terminal which built-in Windows XP and before version.
Hyper Terminal setting:
〔
115200 bps (8-N-1),
Flow control: None
〕
(Properties -> Settings -> ASCII
Setup
…
and select
“
Send line ends with line feeds
”
&
”
Echo typed characters locally
”
)
★
We recommend enable RS232 assign mode for all receivers when you use RS232 command to
control them, and set all receivers assign to only one transmitter to avoid RS232 connection broken
by video channel switching.
Command format: >CMD_Address> Command Parameters
Address, command and parameters are char, not hex code
Enter (LF or CR+LF) is required to execute the command
All accord receivers will run the command and parameters, we also add 3 kinds of user defined
numbers except MAC & IP (Device No
、
Group No
、
Party No) for flexible application:
Mxxxx
The last 4 digits of MAC Address of receiver
e.g.: 221868860123 = M0123
Ixxxx
The last 2 column of IP Address (HEX) of receiver
e.g.: 169.254.012.034 = I0C22
Dxxxx
Device No
e.g.: Device No 1234 = D1234
Gxx
Group No
e.g.: Group No 12 = G12
Pxx
Party No
e.g.: Party No 34 = P34
Cxx
Channel No
e.g.: Channel 12 = C12
ALL
All receivers
Response format: <ACK_Address< Response character
Receivers will response message to transmitter as above format and send CR+LF after response
When send command to multiple receivers they will not response by default.
To enforce response function please add
“
!
”
in front of the commands and receivers will respond in
sequence regarding device number X 15ms (0ms, 15ms, 30ms and so on), so we recommend set
Device No for all receivers if you need response from multiple receivers.
To prevent respond conflict or long time waiting by mass receivers, we do not recommend use
“
!
”
with Gxx, Pxx, Cxx, and ALL