SERATO SCRATCH LIVE 3RD PARTY CONTROLLER QUICKSTART
1.9.0
6
NUMARK DMC2
INSTALLATION
MAC
1. Connect your DMC2 to an available USB
port.
2. Your DMC2 will be detected automatically and
will be ready to use.
WINDOWS
1. Connect your Numark DMC2 to an available
USB port.
2. You will see the following prompt from
Windows: Can Windows connect to Windows
update to search for software?
3. Select: “No, not this time” followed by “Install
automatically”
4. Windows will then notify you that it has found
the device: “Found new Hardware Numark
DMC2, followed by USB composite device”
bubbles will appear.
5. You will be prompted to install 2 drivers. “USB
composite device” and “USB audio device”.
Follow the prompts as per the usual driver
installation method for windows.
6. Once installed, the DMC2 should show a
flashing message in both screens that says “PC
no Link”.
SETUP
Start Scratch LIVE and switch both decks to
internal mode. The DMC 2 should automatically
be in PC mode. A flashing message on both
screens will say: “PC no Link”. You will now be
able to control Scratch LIVE with your DMC2!
BASIC OPERATION
You can browse through your Crate/Track list
(whichever has focus) using the left and right
Knobs (4). If focus is on Crate list, pushing the
knob will move focus to Track List. If focus is
on Track list then pushing the knob will load the
selected track to the respective deck.
PLAYBACK
Use the PLAY and PAUSE buttons to play and
stop your tracks.
SETTING CUES
You can set a temp cue point at the current
position of the playhead, while playback is
paused. Holding the CUE button (24) will play
from the temp cue point.
USING HOT BUTTONS
Hot 1 and Hot 2 buttons control 2 different cue
points. To set a cue point, press one of the Hot
buttons with the SYNC button turned on. To
return to the cue point, turn the SYNC button off,
and press either of the Hot buttons.
USING THE LOOPS
To set a loop during playback, simply press
one of the autoloop buttons. This will create
an autoloop of the duration specified on each
button, ranging from 1/8 bar, to 8 bar. you can
lock the loop by pressing the LOCK button (9) .
You can also use the LOOP IN and LOOP OUT
buttons to set your loop. The loop can be toggled
on/off by pressing the BACKBEAT button (19).
