PACKING LIST
−
Cutting
Head
−
Pole Assembly
−
Rear
Handle
−
Blade Cover
−
Hex Key
−
Instruction Manual
WARNING:
If any parts are damaged or missing, do not operate
this product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
If any parts are damaged or missing, please call customer service
at 1
-
800
-
618
-
7474 for assistance.
UNPACKING
This product requires assembly.
Carefully remove the product and any accessories from the box.
Make sure that all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage or damage
occurred during shipping.
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
ASSEMBLY
POLE AND HANDLE ASSEMBLY
1.
Loosen the shaft coupling A by turning it counter
-
clockwise and
pull out the
pronged side of the
extension pole to the desired
length. Tighten the shaft coupling A by turning it clockwise.
2.
Loosen the shaft coupling B by turning it counter
-
clockwise.
3.
Align the arrow on the handle with the protruded lock pin on the
shaft.
4.
Insert the pole into the handle until the pin locks in place.
5.
Tighten the shaft coupling B by turning it clockwise.
DIS
-
ASSEMBLE POLE AND CUTTING HEAD/HANDLE
To disassemble pole and cutting head or handle,
1.
Loosen the shaft coupling by turning it counter
-
clockwise;
2.
Use a small nail to depress the lock pin in the slot;
3.
Pull them apart.
ADJUSTING THE LENGTH OF THE TELESCOPIC POLE
1. To
adjust
the
telescopic
pole
,
disconnect
the
product
from
the
power
supply. Rotate
the
shaft coupling counterclockwise
to
loosen. Extend
the
pole
to
the
desired
length
.
NOTE
:
Only
extend
the
pole
to
minimum
length
required
to reach
the limb or shrub to be cut.
2.
Lock
the
pole
in
position
by
turning
the
shaft coupling
clockwise
firmly to
secure
.
WARNING
:
Failure
to
lock
the
telescopic
pole
coupling
as
directed
could
result
in
personal
injury
.
POLE AND CUT HEAD ASSEMBLY
1.
Loosen the shaft coupling A by turning it counter
-
clockwise
and pull out
the prong
-
less side of
the extension pole to the
desired length. Tighten the shaft coupling A by turning it
clockwise.
2.
Loosen the shaft coupling B by turning it counter
-
clockwise.
3.
Align the arrow on the cutting head with the protruded lock pin
on the shaft.
4.
Insert the pole into the cutting head until the pin locks in place.
5.
Tighten the shaft coupling B by turning it clockwise.
A
B
B
B
A
A
B
A
5
Model PS45010S
A
B
B
A
