© 2019 GOJO Industries, Inc. All Rights Reserved
Page
4
of
7
module will enter pairing mode. Once paired, the
module will connect to Onvation.
2. Alternately a factory reset may be performed:
If the magnet is held for a long period of time, all LEDs
will turn on. This means a factory reset of the module is
performed. All parameters are erased. The module
enters a “Dispenser Detect” state where a dispense
must be performed after a factory reset.
PAN Modul e Light Pattern s
Status
The 2 module board options function in consistent ways.
There are 3 LEDs on installed on the board. Red, Green, and Blue. These LEDs are turned on with specific patterns
to indicate the board’s status.
State: Un config ure d – Waiting for Dis pens er
In this state, the module has not yet been configured for a specific dispenser type. It will blink 1X per second until the
dispenser type is determined.
The module determines dispenser type when a dispense is performed. The Dispense (EOS) signal is toggled, and
then status is sent to the module. Once the dispenser type is determined, it is saved and is only cleared upon a
factory reset.
IMPORTANT:
Once installed and powered in a dispenser, the module should not be left indefinitely in this state- as it
will consume significantly more power than if it transitions out of this mode.
State: Disp ens er Type Co nfirmation
OR
OR
At startup, the dispenser enters the
dispenser type confirmation
state once it determines the dispenser type
configuration for the module. The LED is turned on
solid
for a 1.5 second period to confirm the dispenser type. After
the module enters this state, it will query the dispenser for its state, if possible, and then will begin initially advertising.
