Scott Safety Protege, User Manual

Page: 46 / 104

22
CHAPTER 3: CONFIGURATION AND SETUP
087-0038 REV L SCOTT SAFETY
Configuration and
Setup Checklist
This section provides the configuration and setup requirements. Table 8 lists the
individual items.
Connecting the Device
to a PC
This section describes connecting the device to a PC.
Required items:
This assumes you have already installed both the SGM and JAVA JRE software.
•
The device
•
A PC
•
USB Cable
•
Power & USB Communications Module
•
AC Power Adapter
1
Start the SGM software by double-clicking the Protégé PCI icon. The icon is
loaded onto the Desktop during a typical install of the SGM software. The Protégé
PCI icon may be located in another location if a custom installation was
performed. See
Figure 17 .
Figure 17 Device Icon
2
Connect the AC Power Adapter cable to the Power & USB Communications
Module, connect the USB cable to the Power & USB Communications Module,
and connect the USB cable to your PC USB cable port.
If this is the initial install of the Power & USB Communications Module, allow the PC
to load and recognize the Power & USB Communications Module before proceeding.
3
Connect the device to the Power & USB Communications Module by sliding the
connector shoe into the back of the device. See
Figure 18 .
Table 8 Configuration and Setup Checklist
ITEM DETAILS
Device to PC connection See “Connecting the Device to a PC” on page 22.
SGM software See “Configuring the Scott Gas Monitor Software” on page 23.
SGM software (defaults) See “SGM Defaults” on page 27.