28
CHAPTER 4: CONFIGURATION AND SETUP
087-0048 REV B
SCOTT SAFETY
Configuring the IR
Connect Software
Parameters
This section describes configuring the IR Connect Software parameters.
The various parameters are shown in
(after installed and confirmed
communications between the IR Connect and the Monitor per a READ DEVICE
performed during installation) and detailed in
. These parameters allow you
to program the individual Monitor to met your needs.
Figure 20
IR Connect Software After Installed
Warning:
After making changes to High/Low Alarm parameters and performing a
WRITE DEVICE command, perform a READ DEVICE command to verify changes.
This ensures desired changes have been stored in memory. Over range WRITES are
not stored in memory. Failure to follow these instructions may result in serious injury
or death.
Summary of Contents for Protege ZM
