Scott Safety HushAir Connect 7500, User Manual

Page: 52 / 120

30
CHAPTER 3: CONFIGURATION AND SETUP
087-0067 REV A SCOTT SAFETY
conform to the National Electric Code, and must comply with all State and local codes
and regulations. Use of incorrect electrical power input may permanently damage the
equipment and could cause serious injury or death to the user.
33339
Table 15 Pre-Operation Checklist - Compressor
ITEM ACTIVITY FREQUENCY DETAILS
Maintenance
schedule Verify Before each
operation Verify that the maintenance schedule is up to
date for the unit. Proper routine maintenance
and documentation are the responsibility of the
organization using the equipment. Maintenance
must be performed in accordance with service
guidelines provided by Scott.
Electrical
power source Check Before each
operation Check the electrical power source. Ensure that
the compressor unit is connected to a suitable
electrical power supply, and that there are no
maintenance procedures in process that would
necessitate a Lock Out/Tag Out of the circuit
breaker or master switch.
Air flow Check Before each
operation Make sure there is nothing close to or on top of
the compressor that could interfere with air
flow. For proper operation, the minimum
clearance established at installation on all sides
and above the compressor must be maintained.
Fresh air
supply Check Before each
operation Make sure nothing is operating in the vicinity of
the compressor air intake which might
contaminate the fresh air supply, such as vehicle
exhaust, chimney smoke, ventilator fumes, or
other source of contamination.
High pressure
connections Check Before each
operation Check the high pressure connections. Ensure
that the high pressure outlet(s) are properly
connected to a suitable high pressure air
receiver. If any connection is loose or damaged,
do not start the compressor until all connections
have been properly repaired and thoroughly
inspected.
Oil level Check Before each
operation, or
at least once a
week Check the compressor oil level prior to each
use. To check the oil, remove the oil fill cap and
check the oil level reading. Replenish as
necessary, using only Anderol 500 oil or
XL-700 oil, available from your local Scott
distributor.
Belt Check Before each
operation, or
at least once a
week Check the belt condition and the tension
Loose
components Check Before each
operation, or
at least once a
week Check the compressor for any loose
components
Remote air
intake Check Before each
operation, or
at least once a
week Check the Remote Air Intake for any leaks