Scott Safety HUSH, Operating Instructions Manual, Page: 19 / 48

3 - Starting and Operating
Stationary Air Compressor System Operating Instructions
17
FINGER SCREWS
Finger Screws
Only the access panel over the purification filters is
removable on this version. There are eleven (11) finger
screws that hold the panel in place: four (4) on each
side and three (3) across the bottom. There are three
(3) non-removable screws across the top that hold the
internal locator bar.
1. Use fingers or a flat-blade screwdriver to loosen the
eleven (11) finger screws on the access panel.
2. Tilt the bottom of the panel out slightly away from
the enclosure.
3. Pull the panel straight out to remove . Place the
access panel in a safe place while performing the
pre-operation checks.
ALWAYS replace the panel prior to starting the
compressor. To replace the enclosure panel:
1. Tilting the panel at an angle, position the internal
locator bar in the top of the opening.
2. Make sure the finger screws all align with their
mating holes in the fixed panel.
3. Secure the eleven (11) finger screws. If necessary,
using a flat-blade screwdriver to snug the screws.
DO NOT OVER TIGHTEN.