Assembly Instructions
1. Begin the assembly of your Scott De-Icer dock mount model by loosening the stainless-steel bolt from the yoke assembly.
Adjust the grey dock-mount housing to the desired angle for water flow and tighten bolt to secure in place. We recommend
that the angle is adjusted at a 45 degree angle facing upward toward the surface.
Fig.1
2. Secure the dock plate to your wooden or metal dock, utilizing the 4 large self-tapping screws and washers.
Fig. 2
3. Once the dock plate has been secured, the stainless-steel pole can be inserted through the dock plate sleeve.
Simply loosen the 2 thumb screws from the dock plate sleeve, insert the pole from the top through the
sleeve by approximately 6 inches, and then re-tighten the 2 thumb screws.
Fig. 3
4. Now, slide the yoke assembly over the bottom of the stainless-steel pole and secure with the bolt provided.
Fig. 4
5. The Scott De-Icer dock mount model easily adjusts for varying water levels by loosening the 2 thumb screws from
the dock plate and raising or lowering the De-Icer. We recommend that you lower the De-icer 12 to 18 inches below
the water surface for optimum performance. Please note, the 2 thumb screws are coated with a special lubricating
compound specifically designed for stainless-steel to ensure proper function. An extra packet of this compound has
been included with your purchase; periodic lubrication of the 2 thumb screws is required for years of problem free use
and for warranty validation.
6. Finally, power can be supplied to your De-Icer utilizing a standard 110 volt receptacle protected by a GFCI. Extension
cords should not be used. Disconnect power when swimmers are present.
!
Do NOT use an extension cord
to supply power to the motor
Always use a GFCI
Always disconnect the power
when swimmers are present
!
Adjusting the position of the De-Icer while in operation will cause
the dock plate thumb screws to strip, resulting in permanent
damage to the dock plate. Always disconnect power before
adjusting and keep the dock plate thumb screws lubricated.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
12"
DOCK-MOUNT
HOUSING
DOCK-MOUNT
BRACKET
THUMB
SCREWS
YOKE
ASSEMBLY
