Removing and Installing Interior Shelves
1. Pull shelf out about 6" (1), until back of shelf
clears the rib on the right-hand side.
2. Tilt up right-hand edge of shelf (2).
3. Remove shelf from unit by pulling out (3).
Insert the shelves as follows:
1. To move to a different position in the unit, insert
shelf at an angle, approximately 15-20°, over the
rib in the side of the unit where you want to place
the shelf. Place the shelf into the unit at an angle to
clear the door.
2. Continue to slide the shelf into the unit at an
angle until it clears the door.
Lower the shelf and push it in completely. Ensure
the raised edge strip is toward the rear of the unit.
IMPORTANT
Make sure the shelves are inserted fully into the
unit.
Removing and Installing Door Shelves
To remove the door
shelf:
1. Grasp shelf in
center, and lift until
the shelf notches (1)
clear the pins (2).
2. Carefully pull the
shelf away from the
door.
To install the door
shelf:
1. Holding the shelf in the center, center the shelf in
the door at the desired location, slightly above the
pins (2).
2. Lower the shelf onto the pins (2).
May 2011
Page 11
SCR33
User's Manual
