FOR THE INSTALLER
Notice:
Scotsman Ice Systems are designed and
manufactured with the highest regard for safety
and performance. They meet or exceed the
standards of UL, NSF and CUL.
Scotsman assumes no liability or responsibility of
any kind for products manufactured by Scotsman
that have been altered in any way, including the
use of any part and/or other components not
specifically approved by Scotsman.
Scotsman reserves the right to make design
changes and/or improvements at any time.
Specifications and design are subject to change
without notice.
Location:
Installation Limitations:
This ice system is designed to be installed indoors,
in a controlled environment:
Min
Max
Air Temperature
50
0
F
100
0
F
Water Temperature
40
0
F
100
0
F
Water Pressure
20 PSI
80 PSI
Voltage
198
253
(Compared to the nameplate)
Operating the machine outside of the limitations is
misuse and can void the warranty.
RO Water Limitation:
Water conductivity must be
no less than 35 microSiemens/cm.
Only install the machine in a location where there
is enough space around it so that it is accessible
for service.
Keep the back of air cooled machines a minimum
distance of 6" from a wall for air circulation. Try to
avoid hot, dirty and crowded locations. Be sure that
the location for the machine is within the
environmental limitations.
Storage Bin:
Tip the storage bin on its back, using parts of the
carton to protect the exterior finish. Remove the
skid and install the legs into the threaded holes in
the bottom of the bin. Turn the leg levelers all the
way in preparation for leveling later. Return the bin
to the upright position, remove paper covering the
bin gasket.
Note: Do not push bin into position, instead lift it
there. Pushing a bin, especially one with ice in it,
can cause damage to the legs and the leg mounts.
Install the appropriate bin top on the bin, according
to the instructions for the bin top.
Ice Machine:
The machine is heavy, so the use of a mechanical
lift is recommended for lifting the machine high
enough to install on top of the bin. After the unit is
placed on the bin, line it up so it is even with the
back side. Secure the machine to the bin with the
hardware provided with the machine.
Remove the front panel and remove any shipping
blocks.
NME954 & FME1204
June 2002
Page 4
