FACTORY STEREO REMOVAL
2009-2010 FORD ECONOLINE/E-SERIES VAN
RADIO REMOVAL:
1. With panel removal tool, unclip panel below steering wheel column, unplug and remove.
2. Unscrew the steering wheel tilt handle.
3. Extract (3) Phillips head screws located on the bottom panel surrounding the steering wheel
column and with panel removal tool unclip the bottom panel and remove.
4. Insert key into ignition and turn key to the On position, then with a pick tool, push up on the
ignition release tab and pull out the ignition switch.
5. With panel removal tool, unclip the top panel surrounding the steering wheel column & remove.
6. With flat head screwdriver, unclip the shifters rubber seal and slide it up to the top of the shifter.
7. Release (4) hooks securing the center console/engine compartment cover and remove.
8. With panel removal tooll, unclip dash/radio panel, unplug and remove.
9. Extract (4) 7mm screws securing radio, unplug and remove.
2007-10 FORD EDGE
2006-08 LINCOLN MARK LT
2004-08 FORD F-150
2007-10
FORD EXPEDITION
2006-09 FORD FUSION
2008-09 FORD TAURUS X
2006-09 MERCURY MILAN
RADIO REMOVAL:
1. Using a panel removal tool, unsnap radio trim panel that surrounds radio, unplug and remove.
2. Remove (4) 7mm screws securing the radio, disconnect and remove.
2003-06 FORD EXPEDITION
RADIO REMOVAL:
1. Extract (2) 7mm screws above instrument cluster
2. Using a panel removal tool, unsnap radio trim panel that surrounds radio and instrument cluster,
unplug and remove.
3. Remove (4) 7mm screws securing the radio, disconnect and remove.
2002-05 FORD EXPLORER (4-DOOR MODELS)
2002-05 MERCURY MOUNTAINEER
RADIO REMOVAL:
1. Using a panel removal tool, unsnap radio trim panel that surrounds radio, unplug and remove.
2. Remove (4) 7mm screws securing the radio, disconnect and remove.
1995-01 FORD EXPLORER (ALL MODELS)
2002-03 FORD EXPLORER SPORT
2001-05 FORD EXPLORER SPORT TRAC
1995-10 FORD RANGER
1995-10 MAZDA B-SERIES PICKUP
1996-2001 MERCURY MOUNTAINEER
RADIO REMOVAL:
1. Using the Ford DIN removal tools, carefully insert into the holes on the outside edges of the
stereo to release the stereo and pull it out of the dash cavity.
2. Unplug all connectors and remove stereo.
3. Extract (2) screws in the dash bezel just above the heater/air conditioning controls.
4. Carefully pry out on the dash bezel to release the fastening clips, unplug any switches (if
equipped), lighter, and remove the bezel.
