Rev.01 07/22
11
7.2 - Without GREEN/BROWN wire ground connection
To pair a new device, proceed as follows:
•
Arm and then disarm the alarm via remote control or override key.
•
Press the ignition simulation switch to ON.
•
The status LED will turn ON for 1 sec.
•
While the LED is ON, simultaneously press both buttons on the remote control or touch the
override key to its receptacle.
•
A Beep and a Bop will confirm the system is in learn mode. Depending on which device is to
be paired either press one of the remote-control buttons OR touch the override key to its
receptacle OR make the magnetic contact transmit (bring contact and magnet together and
then move apart) OR press the button on the opening detector, make the infrared sensor or
wireless hyper-frequency sensor transmit (refer to sensor instructions.
•
If another device needs to be paired, wait 2 sec. before doing so.
•
To exit learn mode, press the ignition simulation switch to OFF.
•
A Bop will confirm the end of the procedure.
