Scorpio Palio pro, Manual

Page: 3 / 12

edge. For first flights it is recommended that the balance
point be at the forward position. Once the motor, speed
controller and receiver are installed, the battery pack can be
attached to the battery mounting plate using hook and loop
tape or similar. The battery pack can still be moved forward
or back on the battery mounting plate to allow minor changes
of the balance point. Add ballast to balance the model if
necessary.
Flying the model.
The initial flights should take place in a complete calm or in
a very light breeze. Long grass is an advantage. Check the
model (wings, tail surfaces etc.), CG position, throw and
sense of deflection of the control surfaces and for smooth
operation of the motor / gearbox. Launch the model
horizontally or into a slight climb into wind, with the motor
running at full power. Allow the model to climb to a safe height,
reduce the throttle slightly and trim the model. Check the
response of the model to the control inputs. If your model
does not handle correctly, switch off the motor and land. If
you are a complete novice, ask a more experienced modeller
for assistance.
We wish you many successful flights and happy landings.
Warning!
This aircraft is designed to give you many enjoyable flights,
however if you exceed the specifications of the aircraft by
using a more powerful electric motor or more than 8 cells
you may compromise the structural integrity of the aircraft.
Keep in mind that good sense is always necessary for safe
modeling and safe flying.
The following parts are necessary to finish the model but
are not included in the kit:
- A SPEED „600“ electric motor with spinner and folding
propeller, S8025s 25A speed controller
- 2 standard servos
- Batteries 1200 - 3000 mAh, 7-8 cells,
- Battery charger
- RC system, minimum 2/3 channels
Content of the kit
No. Description Qty
1 Fuselage 1
2 Wing 2
3 Rudder 1
4 Tailplane 2
5 Canopy 1
Bag B1 1
Bag B2 1
Die cut DC1 1
Instruction manual 1
Decal sheet 1
Bag B1
No. Description Qty
B1-1 Rudder pushrod 1
B1-2 Elevator pushrod 1
B1-3 Rudder plastic tube 1
B1-4 Elevator plastic tube 1
B1-5 Steel wing joiner 1
Bag B2
No. Description Qty
B2-1 Brass tube 1
B2-2 Tailplane Auxiliary Rod 1
B2-3 Wood wing dowel 2
B2-4 Linkage holder 2
B2-5 Tow hook 1
B2-6 Motor screw 2
B2-7 Control horn 2
B2-8 Control horn nuts 4
B2-9 Linkage threaded adapter 2
B2-10 Kwick link 2
B2-11 Allen screw 3
B2-12 Tailplane fastener insert 1
B2-13 Nylon hinge 2
B2-14 Tailplane main rod 1
B2-15 Wing fastener insert 2
B2-16 Special allen wrench 1
B2-17 Temporary screw 2
Die cut DC1
No. Description Qty
DC-1 Tow Hook Support 2
DC-2 Electric Motor Former 2
DC-3 Servo Support 1
DC-4 Servo Support Forward Former 1
DC-5 Servo Support Rearward Former 1
DC-6 Former Triangular Support 4
S2084 Palio pro