Scorpio Miss bipe S2065, Assembly & User'S Manual

Page: 1 / 16

S2065 - Miss Bipe
Technical data
Wing Span 1.080 mm
Length 890 mm
Wing Area 36 dm
2
Weight 1.000 g
Wing Loading 30 g/dm
2
Radio 4 ch
Electric motor/Cells “400” (7/8 Cells)
Introduction
Biplanes possess a special charm due to their low
wing loading and thus low flying speeds, which allow
them to perform unusual manoeuvres that are beyond
many model’s “normal” flight limits. Your new Miss
Bipe is an updated version of the popular Miss Chief
model that has gained an excellent reputation for its
easy flight characteristics.
To improve performance still further ailerons have
been added to give greater manoeuvrability and total
control. This extra control will be highly appreciated
by those who prefer to use the new small brushless
motors capable of supplying the extra power required
for more aerobatic flight.
Before starting construction
Each construction stage is numbered in the correct
sequence and is illustrated by a building sketch with
the same number. Check off each construction step as
you complete it so that if work is interrupted you’ll be
able to resume where you left off. A bracket [ ] is
placed next to each building stage for this purpose.
Where glue is to be applied, the type of glue needed
is indicated. We do not recommend the use of normal
cyanoacrylate! Recommended glue:
5-Minute Epoxy (5')
Checking the kit
[ ] Check that nothing is missing or damaged, if any
parts are missing or damaged please contact the shop
were the model was bought.
Marking the parts
After checking the kit, in order to avoid confusion and
speed up and simplify construction, it is suggested
that you mark the wooden parts with their part
numbers using a pencil. The part numbers can be
found on page 14
[ ] Remove each die cut part and sand accurately.
Store safely.
Equipment needed
Here is the list of tools you will need to complete Miss
Bipe:
[ ] - Modelling knife
[ ] - Scissors
[ ] - Screwdriver
[ ] - Sanding block and paper
[ ] - Set Square
[ ] - Drill with 1.5mm and 5mm bits
[ ] - Transparent scotch tape 20 mm wide
[ ] - Pins
[ ] - 5-Minute Epoxy (5’)
[ ] - Contact glue for polystyrene
[ ] - Double sided Tape
[ ] - Soldering iron and solder/flux